Ultrasonic Based (12V-24V) PCB Board for Automatic Dispenser AUSv1.1/2020-12/24V Specification
Operation Description
As somebody place their hands in front of sensor it starts dispensing sanitiser till time (you had been set) and will never dispense again until someone take off their hands and place it again. Dispensing status LED will glow while the dispensing continues. Dispensing time can vary from 1 to 8 seconds using provided potentiometer.
- ✦ Input Voltage: 12-24V
- ✦ Output Voltage: 12-24V
- ✦ Sensor can be Used: Ultrasonic
- ✦ Microcontroller: 8bit Microcontroller
- ✦ Driven Load: 10Amp
- ✦ Switching: MOSFET based Silent and Fast Switching
- ✦ Indicator LED Output: 5-12V
- ✦ Detection Range Of Sensor: (1-10) Inch
- ✦ Dispensing Time: (1-8) Sec
- ✦ Dimension of Board : Length- 7cm, Width- 7.5cm
- ✦ Microcontroller based design.
- ✦ Wide range of input voltage.
- ✦ Ad-hoc design support.
- ✦ Separate output for Solenoid , Pump and Indicator LED.
- ✦ Solid state switch are used so no noise and no heat generaBon at all.
- ✦ On board potenBometer for changing Dispensing Bme and sensor’s sensiBvity.
- ✦ All types of Pumps can be used.
- ✦ Plug and play design, offers benefits like low labor cost, and be used in DIY projects.