Ultrasonic Based (12V-24V) PCB Board with Buzzer indicator for Automatic Sanitising Tunnel AUS-v1.1/T-2020
Operation Description
As somebody enter in the tunnel, it starts sanitising till time (you had been set) and will never sanitise until 2nd person enter in it again. Status LED will glow while the sanitising continues. Sanitizing time can vary from 5 to 30 seconds using provided potentiometer.
- ✦ Input Voltage: 12-24V
- ✦ Output Voltage: 12-24V
- ✦ Sensor can be Used: Ultrasonic
- ✦ Microcontroller: 8bit Microcontroller
- ✦ Driven Load: 10Amp
- ✦ Buzzer: 5V
- ✦ Switching: MOSFET based Silent and Fast Switching
- ✦ Indicator LED Output: 5V
- ✦ Indicator LED Strip Output: 12V
- ✦ Detection Range Of Sensor: (1-12) feet
- ✦ Sanitizing Time: (5-30) Sec
- ✦ Dimension of Board : Length- 9cm, Width- 5.5cm
- ✦ Microcontroller based design.
- ✦ Buzzer for dispensing indication.
- ✦ High electrical noise immunity .
- ✦ Wide range of input voltage.
- ✦ Ad-hoc design support.
- ✦ Separate output for two Pump and Indicator LED, Strip.
- ✦ Solid state switch are used so no noise and no heat generaBon at all.
- ✦ On board potenBometer for changing saniBsing Bme and sensor’s sensiBvity.
- ✦ All types of Pumps can be used.
- ✦ Plug and play design, offers benefits like low labor cost, and be used in DIY projects.