This is Thermistor 100k NTC with 1 Meter Cable Temperature Sensor for 3D Printer Reprap. The thermistor is a thermally sensitive resistor known for exhibiting a large change in resistance with only a small change in temperature. It is important to note that a thermistor’s change in resistance is non-linear. It follows a pre-defined curve which is provided by the thermistor manufacturer. Positive thermal coefficient (PTC) will increase in resistance with an increase in temperature, and negative ones (NTC) will decrease. However the formula in practice is not linear, so sometimes an accurate table of measurements is better than the linear formula. These measurements can usually be found in the datasheet that accompanies the thermistor.

Features :

• Dissipation power factor: 5 mW/? (static in the air).
• 3D Printer Temperature Sensor.
• 100k Ohm NTC Thermistor.
• NTC Thin Film Thermistor Cable.
• The hot time constant: 7 s(in the air)

Package Include :

1 x Thermistor 100k NTC with 1 Meter Cable Temperature Sensor