SKU: AR-APM-90A
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- 6-pos DF13 cable plugs directly to APM 2.5’s ‘PM’ connector.
- Supports from 2 cells to 6 cell battery.
₹593.53
(Including GST)
This APM Power Module V1.0 is a simple way of providing your APM/Arduflyer with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6P cable. The on-board switching regulator outputs 5.3V and a maximum of 3A from up to a 7S LiPo battery.Special for APM2.5.2 APM2.6 A six wire cable from the Power Module is plugged into your Pixhawk/APM power port. This enables current consumption and battery voltage measurement data to you Flight Controller via the DF13 plug. The six wire cable is approximately 7-inches long. The battery cable is 12AWG extending approximately 6-inches between the male and female XT60 connectors.
Note: The Power Module is only designed to power APM, a RC receiver and APM accessories (GPS, 3DR radio). It is not designed to power servos.
Specifications :
| Product | APM Power Module |
| Max Input Voltage | 28V DC |
| Max Current Sensing | 90A |
| Switching Regulator Max Voltage Output | 5-3V DC |
| Switching Regulator Max Current Output | 3A |
| Totoal Length | 150mm |
| Connector Type | XT60 |
Features :
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- 6-pos DF13 cable plugs directly to APM 2.5’s ‘PM’ connector.
- Supports from 2 cell to 6 cell battery.
Package Include :
1 x APM Power Module V1.0 with XT60 Plug for Pixhawk Flight Controller 2.52 2.6 PIX
